From the course CNC Lathe Programming using G-Code
available from https://gcodetutor.com.
In this lesson, I demonstrate how to drill a hole on the centreline of the component using three different techniques.
G01 normal without pecking,
G83 Peck cycle command and
G73 Chip peck drilling cycle.
I explain how the G Codes work and when to use each one.
For easy to understand CNC Programming tutorials, check out my website
https://gcodetutor.com
Start for free!
Use the coupon code YT152020
to get 15% off any paid CNC course
at https://gcodetutor.com
source